Anyone used keratin to fuse wefts in?

 

I put just a teeny spot of LG on the fusion chip and stuck it on the weft of the hair, then I made my clean part and voila!! I used the tip of the fusion wand to melt the fusion chip into the hair that was holding the weft.  It only took about 5 seconds to melt the glue,or chip whatever you call it, and then I pressed it real good with the top and bottom layers of hair.  Kind of like Sherrie's sandwich method.  I have taken some out  because after some wear the chip turned that white opaque color.  I just used alcohol, and weakened the bond, then a drop of citrus, then a little prayer, and worked it out without too much trouble.  I ordered some keratin, gonna try that instead and see what happens.  I only used about 1/2 of a chip every 3/4 inches or so, kind of along the lines of e-z weft and the microlink technique.  Do you know if there is much difference between the keratin and fusion chips? 

 

 

AMM:  I thought I would go ahead with the install and when It got time to take them out I would come cryin to you or ask for help on the board.  Go ahead and bust my bubble and tell me it will be too hard to take out.  Seriously, any recommendations before I   go into the laboratory? 

 

Yeah you are probably right but I just took the lazy- I mean easy way out and put a tiny fleck on the chip to hold it on the weft.  It just made it clean without having to add heat to the chip twice.  Has anyone found anything magic other than ETOH to take down the fusion?  NO MORE BALDIE (might be more baldie after I take this mess out in a few weeks)