i hace one that holds about 35 rings, i need it that length- not longer cause it has to fit into my belt- i wear a tool belt and place it in the holder each time i use it, i am quick at getting it and putting it back, where do u place yours?
In my Eurolocs kit, I got the threader tool which was basically a ventilating needle holder with a long piece of thin gauge wire looped in it. I went to the craft store and bought a whole spool of wire to have on hand, so when my wire broke I just cut a new piece and screwed it into the ventilating needle holder. You need to use thin wire because it needs to be able to fit in the ventilating needle holder.
Anyway, I make my wire very long, so I can accomodate 100 rings at a time before I need to reload it.
I have been working on (attempting) making an extended length threader/pulling tool/linker for the 2mm size rings. This is some of my progress after quite a bit of whittling and soldering. And gluing.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum
Topic Options
Post Options
Thanks(0)
