QuoteReplyTopic: I-Tips, U-Tips, V-Tips? Posted: June 17 2009 at 9:38am
sherrie215 wrote:
I tips are intended for ring or shrink ie applications. Typically there isnt enough glue in an I tip to properly install by fusion. The U-tip or V tip for fusion are basically just a matter of preference
Ah, right! Now that you mentioned that about the I-tips, I remember hearing that before. Guess I've been gone for this board for a little too long .
sherrie215
Members Profile
Send Private Message
Find Members Posts
Add to Buddy List
Super Elite Member
Joined: December 21 2004
Status: Offline
Points: 4424
I tips are intended for ring or shrink ie applications. Typically there isnt enough glue in an I tip to properly install by fusion. The U-tip or V tip for fusion are basically just a matter of preference
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum
Topic Options
Post Options
Thanks(0)
sherrie215 wrote:
.
