I tips are intended for ring or shrink ie applications. Typically there isnt enough glue in an I tip to properly install by fusion. The U-tip or V tip for fusion are basically just a matter of preference
I tips are intended for ring or shrink ie applications. Typically there isnt enough glue in an I tip to properly install by fusion. The U-tip or V tip for fusion are basically just a matter of preference
Ah, right! Now that you mentioned that about the I-tips, I remember hearing that before. Guess I've been gone for this board for a little too long .
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum