QuoteReplyTopic: Templates? Posted: September 10 2007 at 10:40pm
Where do you buy the little template that you can use to get super clean partings and lay out where to place the individual strand installs? I looked at 101 and say the shields I am looking for but not the templates. Do they even exist or just a myth?
Thanks in advance.
That which doesn't kill you makes you stronger or drives you totally insane. :-)
sherrie215
Members Profile
Send Private Message
Find Members Posts
Add to Buddy List
Super Elite Member
Joined: December 21 2004
Status: Offline
Points: 4424
Hey Karen here is a nifty looking multihole template that has clips on each end. Not sure if the clips would make this more convenient or if the clips would make this more cumbersome.
Hey Karen here is a nifty looking multihole template that has clips on each end. Not sure if the clips would make this more convenient or if the clips would make this more cumbersome.
I've never seen a template like this... are you supposed to pull each little section through those spaces, attach the extensions and then pull out the template?
malibu
Members Profile
Send Private Message
Find Members Posts
Add to Buddy List
Senior Member
Joined: February 17 2006
Status: Offline
Points: 1531
Bridget, I was thinking the same thing but I guess the bonds should be smaller than those holes anyway, hence the clips. Once you undo the clips the template should slide off.
malibu
Members Profile
Send Private Message
Find Members Posts
Add to Buddy List
Senior Member
Joined: February 17 2006
Status: Offline
Points: 1531
I think these would be better than the first ones but does anybody use these? I don't use shields at all but if I did I would rather use the single hole one.
ALL EYES ON ME
asinnamon
Members Profile
Send Private Message
Find Members Posts
Add to Buddy List
Junior Member
Joined: April 02 2006
Location: United States
Status: Offline
Points: 350
I know this is an older thread, but wanted to give my opinion since i have used both shields & template. When I'm doing my own strands, I use the shield. The template is shiny and I can't see what I;m doing because of the glare. However, when I do my mom's, i use the template and LOVE it! I have one without clips on it, so I have to use a couple of my own. I pull hair thru each section, then go thru and do my bonds. When I'm done, I remove the clips and gently slide the template down the length of hair and repostion it to the next area. got mine off ebay too...6 for 6 bucks and they do come with thier own clips, just not attatched to the template
So they're close enough to avoid cross hairs? What do you use to pull them through the holes a micro hook? Is it supposed to make the install faster or just more uniform?
ALL EYES ON ME
asinnamon
Members Profile
Send Private Message
Find Members Posts
Add to Buddy List
Junior Member
Joined: April 02 2006
Location: United States
Status: Offline
Points: 350
Yup, you use a hook to pull the hair thru the template. yes, I find these a lot easier to deal with in respect to cross hairs. and for me, on my mom's hair, the multi hole templet makes installs much faster. she has a lot of short hairs that are growing out, so sectioning is a PITA!
milachkaa
Members Profile
Send Private Message
Find Members Posts
Add to Buddy List
Junior Member
Joined: May 17 2006
Location: United States
Status: Offline
Points: 101
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum